Slate-Lite Extreme Protection is a two-component protective seal with prior priming for maximum loads.
It is suitable for wall and floor indoors as well as for the wet area and reliably protects the Slate-Lite stone surface from soiling. The seal is suitable for wet areas, but not for standing water.
The result impresses with easy cleaning, a smooth surface and little to no color deepening.
- Suitable for: walls, shower & bathroom (wet area, no standing water)
- Durability: high
- Consumption: approx. 130–150 g/m² per coat
- Appearance: little to no color deepening, smooth finish
- Care: easy to clean
Application (short version):
The surface must be clean, dry and free of dust and grease. First apply the primer crosswise with a short-pile roller (only light pressure to avoid bubbles) and allow to dry for at least 3 hours.
Then mix the two components in a 2.5:1 ratio and apply evenly with a short-pile roller (again only light pressure, otherwise white bubbles may form). Allow to dry sufficiently and clean tools with water immediately after use.
Multiple coats increase the protective effect: at least 1 coat for lightly stressed surfaces and wet areas in shower & bathroom, at least 2 coats for heavily stressed surfaces (e.g. kitchen splashbacks).
Note: At higher temperatures, the material cures significantly faster than stated in the instructions and data sheet.
Please test each accessory product in a small, inconspicuous area before use and always follow the information provided in the relevant data sheets. In particular, drying and processing times, substrate requirements, and application temperatures must be observed. The user is responsible for proper application and for the results achieved.